'-----------------------------------------------------------------
'                       RC5SEND.BAS
'                   (c) 2003-2005 MCS Electronics
' code based on application note from Ger Langezaal
'   +5V <---[A Led K]---[220 Ohm]---> Pb.3 for 2313.
' RC5SEND is using TIMER1, no interrupts are used
' The resistor must be connected to the OC1(A) pin , in this case PB.3
'-----------------------------------------------------------------
$regfile = "2313def.dat"
$crystal = 4000000

Dim Togbit As Byte , Command As Byte , Address As Byte

Command = 12                                                ' power on off
Togbit = 0                                                  ' make it 0 or 32 to set the toggle bit
Address = 0
Do
   Waitms 500
   Rc5send Togbit , Address , Command
Loop
End

ÊÀÊ ÏÐÈÑÂÎÈÒÜ PB.3 ÂÛÂÎÄ RC5 ÊÎÄÀ,      "CONFIG RC5 = PINB.3" ????? ÄÀ???????