Форум РадиоКот

Код: Выделить всё

//-----------------------------------------------------------------------------
// Includes
//-----------------------------------------------------------------------------

#include "c8051f320.h"        
#include "USB_API.h"


xdata BYTE In_Packet[3]; //массив для принимаемых данных с компа


/*** [BEGIN] USB Descriptor Information [BEGIN] ***/
code const UINT USB_VID = 0x10C4;
code const UINT USB_PID = 0xEA61;
code const BYTE USB_MfrStr[] = {0x1A,0x03,'S',0,'i',0,'l',0,'i',0,'c',0,'o',0,'n',0,' ',0,'L',0,'a',0,'b',0,'s',0};                      // Manufacturer String
code const BYTE USB_ProductStr[] = {0x10,0x03,'U',0,'S',0,'B',0,' ',0,'A',0,'P',0,'I',0}; //  Product Desc. String
code const BYTE USB_SerialStr[] = {0x0A,0x03,'4',0,'3',0,'2',0,'1',0};
code const BYTE USB_MaxPower = 150;           // Max current = 300 mA (15 * 2)
code const BYTE USB_PwAttributes = 0x80;      // Bus-powered, remote wakeup not supported
code const UINT USB_bcdDevice = 0x0100;       // Device release number 1.00
/*** [ END ] USB Descriptor Information [ END ] ***/


void Port_Init(void)
{
   /* Initialize Crossbar and GPIO */
   /* Все порты настроены на выход */
    P0MDOUT   = 0xFF;
    P1MDOUT   = 0xFF;
    P2MDOUT   = 0xFF;
    P3MDOUT   = 0x01;
    XBR1      = 0x40;      
}


void Initialize(void)
{
   Port_Init();                           // Initialize crossbar and GPIO   
}


//-----------------------------------------------------------------------------
// Main Routine
//-----------------------------------------------------------------------------
void main(void) 
{
   PCA0MD &= ~0x40;                       // Disable Watchdog timer

   USB_Clock_Start();                     // Init USB clock *before* calling USB_Init
   USB_Init(USB_VID,USB_PID,USB_MfrStr,USB_ProductStr,USB_SerialStr,USB_MaxPower,USB_PwAttributes,USB_bcdDevice);
   Initialize();
   USB_Int_Enable();
         
   while (1);  //вечный цикл в ожидании прерывания USB  
}


//-----------------------------------------------------------------------------
// Interrupt Service Routines
//-----------------------------------------------------------------------------
void USB_API_TEST_ISR(void) interrupt 16       // ISR for USB_API
{
  bit temp_Chanel;
  BYTE INTVAL = Get_Interrupt_Source();

  if (INTVAL & TX_COMPLETE)
  {
      USB_TX_READY = 1;
  }

  if (INTVAL & RX_COMPLETE)
  {
       Block_Read(In_Packet, 3);
       P0 = In_Packet[0];
       P1 = In_Packet[1];
       P2 = In_Packet[2];    
  }
    
  if (INTVAL & DEVICE_OPEN)
  {
    USB_START = 1;
  }
}