i will check and return
Posted after 47 minutes 14 seconds:[uquote="deop",url="/forum/viewtopic.php?p=3665903#p3665903"][uquote="Gürcan",url="/forum/viewtopic.php?p=3665520#p3665520"][uquote="radioandrei74",url="/forum/viewtopic.php?p=3665515#p3665515"]Gürcan!!!
очень красивые платы. вы поделитесь файлами для повторения вашего варианта платы?
very nice boards. will you share the files to repeat your Board option?[/uquote]
I will re-share the last file of this project
Posted after 17 minutes 20 seconds:Hi friends I uploaded the final version of the file Fixed a few text errors Proteus 8.8 and I've uploaded as a GerBer file[/uquote]
Front Panel Control Unit_STM32F103_Rev 2.0.2 GerBer.rar при загрузке на jlcpcb нижний слой выглядит не очень, точно с файлом grab всё в порядке?
Спойлер
[/uquote]
deop .: hi gerber I checked the file usually Analysis Results give some errors I know I've seen the same errors when printing but I did not get a problem in the printing part is already an error if they do not take production because I've lived one-to-one I shared a picture re-upload the file if you want to check again
Posted after 26 minutes 58 seconds:hello gerber friends cam350 v10.0.1 I opened the files as it appears in the pictures there is no problem, usually without checking the files to print and then order
