Шукаю схему для провірки конденсаторів

[Олег Резистор]

Шукаю схему для провірки конденсаторів малї ємності приблизно від 100пікофарад

Ми російськомовний ресурс і потрібно хоча б назва теми писати російською мовою. Якщо не знаєте російської мови, то заголовок теми з української на російську можна перевести за допомогою гугла.
Або Ви теж з цієї команди, коли добре знаючи російську мову пише тут не по російськи.

тему закрив. aen


http://radiokot.ru/forum/viewtopic.php?p=645568#p645568

[falkonist]

http://elm-chan.org/works/cmc/report.html

[Borodach]

Look here at this site. There are many different circuits,
though they are in Russia.

http://forum.cxem.net/index.php?showtopic=13268

[Borodach]

Capacitance meter can be very helpful in identifying old components where its mark has been erased or became unreadable. Such instrument can be quite expensive, but fortunately we can build it easily with much lower cost. The capacitance meter described here can measure any capacitor between 1pF and 10uF. Here is the schematic diagram of the circuit:



You can just use a connector for the voltmeter, and the circuit becomes a capacitance meter adapter for your general purpose voltmeter. Just plug the input of your voltmeter to this capacitance meter circuit and now your voltmeter becomes capacitance meter. You can use an analog voltmeter or digital voltmeter. If you use a digital voltmeter, make sure your digital voltmeter is a dual/single slope type reading, since it has an inherent averaging function. If your digital voltmeter is a fast sampling type, then you need to insert a resitor-capacitor filter between this capacitance meter circuit and the voltmeter. A 1k resitor and a 10uF electrolytic capacitor sould be enough for the filter. Analog voltmeter doesn’t need any filter since its mechanical inertia acts like a low-pass filter in nature. More information can be found at ... .